MicroNet Technology SP5001A/S - Manual (Page 67)

Setting IP address provide PC setup Default Gateway Address
-mask
Assign the VoIP gateway’s Subnet Mask
-gate
Assign the VoIP gateway’s default gateway
-nat
Provides Network Address Translation function
Enable the NAT function when share the connection to your PCs.
-dhcp
Dynamic host configuration (0=Off, 1=On)
-sntp
Simple Network Time Protocol (0=No update, 1=Specify server
IP). When SNTP function is activated, users have to specify a
SNTP server as network time source
Example : ifaddr -sntp 1 168.95.192.12
-dns
Specify the DNS server’s IP address
-timezone
Set local time zone according to GMT
-ipsharing
Enable this function when the VoIP gateway behind the NAT
router or IP Sharing devices.
Example : ifaddr -ipsharing 1 61.219.198.204
Note :
If you don’t have static public IP address, then the dedicated IP address is not
necessary in the command, for example : ifaddr -ipsharing 1 However, dynamic IP
Address is not working in Peer-to-Peer mode.
-server
specify EMS Server IP address
-id
specify EMS Server ID
-pwd
specify EMS Server password
-emstime
specify EMS cycle time
The EMS (Element Management System) is expressly built to simplify deployment,
configuration and management of network equipment and to help you streamline
delivery of the high-demand services and capabilities enabled.
Note:
66