Minicom Advanced Systems Smart IP Extender - Manual (Page 16)

SMART IP EXTENDER
15
6. Press Enter. Some device information and a prompt appear.
7. Type config and press Enter. Configuration questions appear. DHCP must be
disabled. You can change the IP address, net mask and default gateway. Pressing
Enter without entering values keeps the default values. To contact IP Extender
from outside the LAN configure a gateway. To remove an already configured
gateway, type 0.0.0.0.
The last question – enable IP access control – concerns switching IP packet
filtering on or off. This can re-enable access to IP Extender after an incorrect IP
access configuration has been activated. Page 47 has more information on IP
access control.
8. Confirm the settings, IP Extender resets the configuration.
(B) Use a crossover Ethernet cable to connect the IP Extender to the computer back-
to-back.
Set the IP address of the computer to 192.168.0.1 and type 192.168.0.220 into the
Address box of the web interface to carry out the IP configuration.
21. Mouse, Keyboard and Video configuration
The correct operation of the client mouse depends on the following two settings.
IP Extender mouse setting
To make the remote keyboard and mouse work properly the IP Extender settings for
the host's mouse and keyboard types must be correct. Check the settings in the IP
Extender front-end. See page 27.
Host system mouse settings
The host operating system has various settings for the mouse driver. IP Extender
works with accelerated mice and is able to synchronize the host with the client
mouse pointer. This is further discussed on page 23.
The following may prevent proper mouse synchronization.
Special vendor-specific Mouse drivers disrupt the synchronization process. Ensure
these are not on the host system
Windows XP has a setting ' enhanced pointer precision’. Deactivate it.