Monster Power HTPS7000 - Manual (Page 13)

5
STEP 2 Outlet Programming
All of the PowerSource's outlets located on the rear panel are "programmable". This means in order to program
each outlet pair, you must use the front panel buttons “MENU” and “SET” (Figure 2). These buttons enable you to
program between “switched on”, “switched on after delay” and “unswitched" (always on) settings independently
on each outlet pair. You can change the settings, when necessary. Using the outlet pair labeled as “AUDIO FILTER”
as an example, the following diagrams illustrate how to program the outlets:
A) Power up the PowerSource: Press the “ON/OFF” switch once to power on the unit. The unit will start
the power on process. Once the process is finished, the display will show the main line voltage similar to
Figure 2.
Note: The power-on process may take up to 60 seconds since any outlet pair can be configured as “Switched on
after Delay”. You can see any outlet pair’s power status LED on the front panel (refer to page 17)
B) Set Outlet Pair to “Switched On”: Press “MENU” until the display shows the status of the AUDIO outlet
pair. Press “SET” button until the DELAY TIME changes to “0” (zero), the display will resemble Figure 3.
The “0” (zero) delay time setting indicates “Switched On” mode for the AUDIO outlet pair. This outlet pair will be
live once the PowerSource is switched on by pressing the front panel “ON/OFF” button, or by an external signal.