Monster Power HTPS7000 - Manual (Page 21)

13
STEP 9 Video AC Outlet Hookup
Isolated Monster Clean Power
™
Stage 5 Video Filter: Optimized to reduce noise generated by video
equipment. Isolates video components from connected digital, analog audio and video components for maximum
rejection of interference.
NOTE: You may want to program these outlets to be “unswitched” (see page 7, fig.5) as some components
perform best when powered continuously. A VCR, for example, should be plugged into one of these to avoid the
hassle of resetting its clock if power is interrupted. Whether the PowerSource
™
is on or off, any component plugged
into these outlets can receive power continuously as long as your PowerSource is plugged into a properly grounded
120 volt wall socket, and the pair is programmed as “unswitched”. You can plug any type of analog video
component (e.g., VCR, camcorder, TV, receiver) into these two Video AC outlets.
A) Attach a Monster
®
Power ID label to each component’s power cord before you plug it into the color-coded
PowerSource
™
outlet.
B) TV/PROJECTOR: Plug your TV or projector's power cord into the corresponding TV/PROJECTOR outlet.
C) VCR: Plug your VCR power cord into the corresponding VCR outlet.
Illustration of rear panel showing Video Filter