Monster Power HTPS7000 - Manual (Page 31)

23
TROUBLESHOOTING (CONTINUED)
Possible Cause #3:
The PowerSource's power cord is plugged into an outlet on the back of one of your components and the component
is not turned on.
Possible Solution:
• Turn the component on.
NOTE: For the best possible performance, plug the PowerSource into a wall outlet, not an outlet on another
component.
Possible Cause #4
The PowerSource is defective.
Possible Solution:
• Please see page 31 for warranty information.
PROBLEM – PowerSource is not providing power to the components.
Possible Cause #1:
The component is plugged into an outlet programmed as “switched on” or “switched on after delay” and the
PowerSource has not been turned on.
Possible Solutions:
• Press the ON/OFF button on the PowerSource. The components plugged into the PowerSource's outlets
programmed as "switched on” should be turn on immediately.
• Press the ON/OFF button on the PowerSource and wait for a few seconds for the components plugged into
the PowerSource's outlets programmed as “switched on after delay” to be turn on.
OR, plug the component into an outlet programmed as "unswitched".