Monster Power HTPS7000 - Manual (Page 17)

9
STEP 5 Remote AC Control Hookups
This feature allows you to turn your PowerSource
™
on/off via your A/V receiver or preamplifier.
A) Plug the Remote AC Control Cord’s (included) female plug into your PowerSource REMOTE IN AC 120V
jack (see diagram below).
B) Plug the Remote AC Control Cord’s 2-prong male plug into a switched AC power outlet on a receiver
or preamplifier. When you turn on your receiver or preamplifier, the PowerSource's outlets programmed
as “switched on” will be turned on immediately. However, the PowerSource's outlets programmed as
“switched on after delay” will be turned on after a delay set by the DELAY TIME setting.
Illustration of rear panel showing remote in AC 120V