Motorola CAJUN P880 - Manual (Page 23)

Cajun P880 Routing Switch Installation Guide 1 - 13
Installing the Modules
* Note: All Cajun media modules are hot-swappable.
To install modules in the chassis:
1. Carefully remove each module from its box, leaving the module
in its antistatic wrapping.
2. After taking appropriate antistatic precautions, as described in
"Preventing Electrostatic Discharge”, earlier in the chapter,
carefully remove the module from the antistatic wrap.
3. Open the Ejector Tabs until the stops make contact with the face
plate (Figure 7).
Figure 7. Installing Modules
4. Insert the module into the chassis (Figure 7).
5. Push on the center of the module pushing it into the chassis. The
ejectors will snap into place.