M&S Systems XDM4600 - Manual (Page 12)

M&S Systems | 800.421-1587 | www.mssystems.com 7
XDM
4600
Set Time and Date
1. Press the EDIT button, then the TIME/DATE button. These buttons are located on the back of the
remote. Use a paperclip or similar tool to press these buttons. The display on the front of the
remote shows SET HOUR.
2. Press VOLUME+ or VOLUME- to select the hour. The remote cycles through a 12 hour clock (AM
and PM) and then a 24 hour clock. A PM shows on the display for PM times. There is no display for
AM.
3. Press CH+ and the VOLUME buttons to set the minutes, date, year, and day.
4. Wait a few moments and the remote returns automatically to its normal mode.
Learn Mode
The XDM46R is preprogrammed to control the volume at the Zone Keypads. You must transfer other
signals from the original audio equipment remotes by using Learn mode.
WARNING THE VOLUME COMMANDS ARE PREPROGRAMMED. DO NOT LEARN THE VOLUME
FUNCTIONS FROM YOUR SOURCE REMOTES.
1. Press the LEARN button on the back of the Universal remote. Use a paperclip or similar tool to
press this button. The display shows LEARN blinking.
2. Press the device button of the audio source you want to transfer a signal for.
3. Press a storage button. This is the button that will be used to perform the signal you transfer. The
word LEARN stops blinking. The unit is now prepared to accept input from the original remote.
4. Place the original remote so that its infrared beam points at the bottom end of the XDM46R. The
two remotes should be 2-3 inches, or 5-8 centimeters, apart.
5. Press and hold the button on the original remote that contains the signal you want to transfer. When
the information has been transferred, the XDM46R display shows OK. Then the word LEARN starts
blinking again.
6. Repeat steps 3-5 until all learning is complete.
7. When you are finished, wait 15 seconds and the XDM46R returns to its normal mode.
Example
To transfer the signal that turns on the DVD player:
1. Press LEARN on the back of the XDM46R.
2. Press the DVD button on the front.
3. Press and hold the POWER button.
4. Point the original DVD remote at the XDM46R and press the POWER button on the original DVD
remote. Hold until the display shows OK.
To use the XDM46R to turn on the DVD player, press DVD, then POWER.
Note: If the display shows ERROR, repeat steps 3-5. Make sure you follow all steps carefully.
115951B.pdf 12 115951B.pdf 12 12/16/2005 8:06:46 AM 12/16/2005 8:06:46 AM