Microsoft C4500 - Manual (Page 88)

Adding paper, Toner and Staples
80
6
Loading Paper into the Paper Trays
The following procedure explains loading paper (in paper tray 2 as an example).
Important
❒ Tray 1 uses only Letter- sized paper (8 1 /
2
” × 11”K). If you want to load A4K,
contact your service representative.
❒ The position of the side and end fences can be changed in tray 2, 1 tray paper
unit, and 2 tray paper unit. Paper of various sizes can then be loaded in them.
When changing paper size, see “Changing the Paper Size”.
❒ Do not stack paper over the limit mark.
A
Carefully pull out the paper tray until it stops.
B
Square the paper and load it print side up.
C
Carefully push the paper tray fully in.
Note
❒ If you load a paper size that is not selected automatically, you will need to
specify the paper size with the control panel.
Reference
p.83 “Changing the Paper Size”
p.86 “Changing to a Size That is Not Automatically Detected”
AQD027S
AQD028S