MaxTech Plug & Play Internal Voice/FAX/Data/SVD Modem - Manual (Page 12)

10
DTR toggle
&D2 Modem hangs up, returns to the
Command Mode after DTR toggle
&D3 Resets modem after DTR toggle
&F_ &F Recall factory default configuration
&G_ &G0 Guard tone disabled
&G1 550 Hz guard tone
&G2 1800 Hz guard tone
&K_ &K0 Disable flow control
&K3 Enable RTS/CTS hardware flow
control
&K4 Enable XON/XOFF software flow control
&L_ &L0 Modem is set up for dial-up operation
&M_ &M0 Asynchronous operation
&S_ &S0 Force DSR Signal High (ON)
&S1 DSR off in command mode, on in on-line
mode
&T_ &T0 Ends test in progress
&T1 Perform Local Analog Loopback Test
&T3 Perform Local Digital Loopback Test
&T6 Perform a Remote Digital Loopback Test
&V &V0 Displays Active Profile
&W_ &W0 Stores the active profile as Profile 0
&W1 Stores the active profile as Profile 1
&Y_ &Y0 Configuration Profile 0 active upon
Power on or reset
&Z n=x n=0-3 Store phone number x into non-volatile
RAM
%E_ %E0 Disable auto-retrain
%E1 Enable auto-retrain
%X_ %X0 Disable re--dialing suppression
%X1 Enables re-dialing suppression
#CID=n n=0 Disable Caller ID
n=1 Enables Caller ID with formatting (date,
time, number, name)
n=2 Enables Caller ID without formatting
#CID? Displays current Caller ID mode
#CID=? Returns Caller ID capabilities of modem.
3.5 MNP/V.42/V.42bis Commands
%C_ %C0 Disable MNP Class 5 and V.42bis data