MaxTech Plug & Play Internal Voice/FAX/Data/SVD Modem - Manual (Page 4)

2
(e.g., Windows 95),
or
B) A Plug and Play Revision 1.0a compliant PC.
Proceed to Section 2.3 now if you have every-
thing required.
If you have neither 2A or 2B above, youneed to
install Windows 95 to provide Plug and Play function-
ality to your PC.
2.3 Hardware Installation
Installation of this modem requires opening and
manipulating your PC. Exercise caution at all times
when working with AC powered and static-sensitive
equipment. Turn off and unplug your PC before instal-
lation. Discharge any static electricity from your body
by touching any bare metal surface of the PC system,
such as its power supply cover.
1. Turn off and unplug your computer from the AC
outlet.
2. Remove your computer's cover (refer to your
computer's owner's manual).
3. Select any available half-card slot, and then re-
move the slot cover (refer to Figure 2-1).
4. Carefully slide the internal modem into the slot
you have chosen, applying even pressure until
the modem is completely seated in the slot.
5. Fasten the retaining bracket with the screw from
the slot cover. Make sure the modem is properly
aligned. Store the slot cover for future use.
6. Replace the computer cover and plug in your
computer.
Figure 2-1 Expansion Slots