MaxTech Plug & Play Internal Voice/FAX/Data/SVD Modem - Manual (Page 6)

4
2.4.1.1 Windows 95 Release 4.00.950
When Windows 95 starts for the first time after
card installation, it detects the modem and displays the
New Hardware Found dialog box.
Under New Hardware Found, when asked to
“Select which driver you want to install for your new
hardware,” click on “Driver from disk provided by
hardware manufacturer.” Click “OK.”
The Install From Disk dialog box now instructs
you to “Insert the manufacturer's installation disk into
the drive selected, and then click OK.” Insert the
modem's driver diskette into the disk drive and type A:\
(or B:\ if inserted in drive B) in the “Copy manufacturer's
files from:” box. Click “OK.”
Windows 95 may request its own installation
disks or CD-ROM for some files. Insert the Windows
95 disks or CD-ROM as required. When all necessary
files are copied, the modem is configured. Windows 95
will assign the modem a COM port and IRQ line.
Proceed to Section 2.5.
2.4.1.2 Windows 95 Release 4.00.950 B
When Windows 95 starts for the first time after
card installation, it detects the modem and displays the
Update Device Driver Wizard.
Insert the driver disk into the disk drive and click
“Next.” Windows will find the driver on the driver disk.
Click “Finish. Windows 95 may request its own instal-
lation disks or CD for some files. Insert the Windows 95
disks or CD as required.
Windows will now find a second device on the
modem. Make sure that the driver disk is still in the disk
drive and click “Next.” Windows will find the second
driver. Click “Finish” to complete the installation.
When all necessary files are copied, the modem
is configured. Windows 95 will assign the modem a
COM port and IRQ line. Proceed to Section 2.5.