MaxTech Plug & Play Internal Voice/FAX/Data/SVD Modem - Manual (Page 13)

11
compression
%C1 Enable MNP Class 5 data compression
only
&Q_ &Q0 Direct data link only (same as \N1)
&Q5 V.42 data link with fallback options
&Q6 Normal data link only (same as \N0)
\A_ \A0 64-character maximum MNP block size
\A1 128-character maximum MNP block
size
\A2 192-character maximum MNP block size
\A3 256-character maximum MNP block size
\Bn Send a 1/10 second line break to the modem,
where n = 1 to 9. At normal connect, the default
is 3
\J_ \J0 DTE speed is independent of modem
connect speed
\J1 DTE speed matches the modem connect
speed
\Kn Set break control, where n= 0 to 5. The effect of
this command depends on the modem’s
operating condition. Default is 5.
\N_ \N0 Normal data-link only
\N1 Direct data-link only
\N2 MNP data link only
\N3 V.42/MNP/Normal data link
\N4 V.42 data link only
\N5 V.42/MNP/Normal data link
\N7 V.42/MNP/Normal data link
\Q_ \Q0 Disable flow control
\Q1 XON\XOFF flow control
\Q3 RTS\CTS flow control
\T n Inactivity timer (n=0-255 minutes)
\V_ \V0 Disable error correction protocol result
code
\V1 Enable error correction protocol result
code
\V2 Enable error correction protocol result
code
\X_ \X0 If XON/XOFF flow control is enabled,
do not pass XON/XOFF to remote
modem or local DTE
\X1 If XON/XOFF flow control is enabled,