MaxTech Plug & Play Internal Voice/FAX/Data/SVD Modem - Manual (Page 19)

17
C O M p o r t s : 1, 2, 3, 4
IRQ lines: 3, 4, 5, 7, 9, 10, 11, 12, 15
FAX Group: Group III Send/Receive
Standard
FAX Command set: EIA/TIA-578 Service Class 1,
EIA/TIA-SP2388 Service Class
2
Transmit level: -11 dBm +/- 1 dB
Receiver Sensitivity: -39 dBm (V.34); -43 dBm (all
other protocols)
UART: 16550 compatible
Data format: 300-115200 bps
Power: 0.75 W
T e m p e r a t u r e : 0 to 55 degr ees C (Oper at ing)
Caller ID: Yes
PnP: Revision 1.0a
Speakerphone: Full-duplex with DSP echo
cancellation
Appendix B - Notices
FCC Compliance
This equipment complies with Part 68 of the FCC Rules. On
this equipment is a label that contains, among other informa-
tion, the FCC registration number and Ringer Equivalence
Number (REN) for this equipment. You must, upon request,
provide this information to your telephone company.
If your telephone equipment causes harm to the telephone
network, the Telephone Company may discontinue your
service temporarily. If possible, they will notify in advance.
But, if advance notice is not practical, you will be notified as
soon as possible. You will be informed of your right to file a
complaint with the FCC.
Your telephone company may make changes in its facilities,
equipment, operations, or procedures that could affect proper
operation of your equipment. If they do, you will be notified in
advance to give you an opportunity to maintain uninterrupted
telephone service.
The FCC prohibits this equipment to be connected to party
lines or coin-telephone service.
In the event that this equipment should fail to operate
properly, disconnect the equipment from the phone line to
determine if it is causing the problem. If the problem is with the
equipment, discontinue use and contact your dealer or ven-
dor.