Motorola PR400 - Manual (Page 50)

August, 2004 6881096C24-A
5-16 Radio Alignment Procedures: Radio-to-Radio Cloning
Procedure:
1. Turn source and target radios off.
2. Connect cloning cable (AAPMKN4003) to the side connector of both radios.
3. Turn on the destination radio.
4. Press and hold the two side buttons at the same time on the source radio and then power up the
source radio (
Figure 5-12 ). Both radios produce a “clone-entry” tone.
5. Release both side buttons, 1 and 2.
6. When cloning is completed, the source radio produce’s a “clone-exit” tone and both the source
and destination radios reset.
7. Turn both radios off.
8. Disconnect the cloning cable from both radios and turn them on for normal operation.
Figure 5-12. Side Button Locations
P1
P2
1
2
3
4
5
6
7
8
9
*
0
#
Side Button 1
Side Button 2