Motorola PR400 - Manual (Page 55)

6881096C24-A July, 2004
Full Keypad Model Disassembly and Re-assembly: Disassembling and Re-assembling the Radio — General 6-5
7. Rotate the bottom of the chassis up about 20
°
to disconnect the keyboard flex cable connector.
Push down 2 end tabs to release flex connector at the bottom of the chassis.
8. Rotate the chassis counterclockwise out of the housing and position next to the housing. Take
care not to damage the speaker and microphone wires that are still connected to the chassis
(
Figure 6-5 ).
9. Unplug the speaker wire assembly from the 2-pin connector on the chassis.
10. Unplug the microphone wire assembly from the socket on the chassis.
11. Move the chassis away from the housing and place on a clean work surface.
Note: The speaker wire assembly microphone wire assembly and keypad flex cable connector
connecting the front housing assembly and the chassis prevent the two units from being
completely separated
Figure 6-4. Keyboard Flex Connection
Figure 6-5. Microphone and Speaker Connections
Radio Chassis
Flex Connector
Speaker Connector
Microphone
Connector