Motorola PR400 - Manual (Page 64)

July, 2004 6881096C24-A
6-14 Full Keypad Model Disassembly and Re-assembly: Disassembling and Re-assembling the Radio — General
2. Position the radio ( Figure 6-19 ), and reconnect the flex connector from the keyboard into the con-
nector located on the bottom of the main board, pushing up the 2 end tabs.
3. Slide the volume potentiometer and frequency switch shafts into their respective holes in the front
cover. Look through the accessory connector opening to make certain that the wires are not
pinched, between shroud and housing.
4. Push the topside of the board chassis upward until it touches the housing end. Before snapping
the board into the housing, perform the following checks:
a. Open the dust cap and ensure the wires are not pinched between the shroud and housing.
b. Ensure the O-ring is seated in the groove.
c. Ensure that the bottom side of the dust cap is fully pressed into the housing before the
snapping the board into place.
Figure 6-18. Microphone and Speaker Wires Re-assembly
Figure 6-19. Keyboard Flex Cable Connection
Speaker Connector
Microphone
Connector
Shroud
Flex Cable Connector
Radio Chassis
End Tabs