MITSUBISHI ELECTRIC DX-TL5716U - Manual (Page 20)

16
Front view
1 POWER indicator
When the POWER button is pressed while the MAIN
switch on the rear of this recorder is ON, this indicator
illuminates. When this recorder is in the standby status
or the MAIN switch on the rear of this recorder is OFF,
this indicator goes out. It takes about 1 to 2 minutes
for this recorder to be ready for operation after the
POWER button is pressed. When this recorder is in the
process of operation transition such as startup, this in-
dicator blinks and other operations are not acceptable.
2 REMOTE jack
Jack to connect the remote control unit (optional).
3 ACCESS indicator
This indicator illuminates when this recorder is access-
ing the internal HDD or externally connected devices.
Before pressing the POWER button, wait until the indi-
cator goes out and "POWER OFF" is displayed on the
LCD.
4 COPY indicator
This indicator illuminates during copy. It blinks at the
start and end of copy operation.
5 BACK UP indicator
This indicator illuminates during archive. It blinks at the
start and end of archive operation.
6 ALERT indicator
This indicator blinks when the recorder notifi es an im-
portant event such as an error occurring in it.
7 LOCK indicator
This indicator illuminates while the simple lock or the
password lock is enabled.
8 TIMER indicator
This indicator illuminates while this recorder is in the
timer recording mode or timer recording standby mode.
It blinks when an error is found in the timer program.
9 M-DET indicator
This indicator illuminates while the motion detection
function is enabled. It blinks during motion detection
recording.
10 PRE ALARM indicator
This indicator illuminates when the pre-alarm recording
or pre-emergency recording is enabled.
11 COM (COMMUNICATION) indicator
This indicator illuminates when this recorder starts
communicating via LAN.
12 REC/STOP button
When this button is pressed, this recorder starts re-
cording and the button illuminates. When this button is
held down for 2 seconds or longer, this recorder stops
recording and the button goes out.
When this button is held down for 2 seconds or longer
during alarm recording or emergency recording, this
recorder stops recording. This recorder does not stop
recording during timer recording even when this button
is held down.
13 SPLIT button ( , , , , )
When this button is pressed, the screen displays in the
selected split display mode.
C to E buttons
These buttons are used to set the menus.
Major operations and their functions
1 3 4 5 6 7 8 9 10 11 12
19 20 21
15 14 13 16 2
17 18