MITSUBISHI ELECTRIC DX-TL5716U - Manual (Page 41)

37
Menu settings/Device registration
Registering the internal HDDs
Step
1 Press the SET UP button on the front panel of
the recorder or left-click the mouse.
or
• <Main menu> is displayed.
Step
2 Select [HDD registration].
HDD registration
• <HDD registration> screen is displayed.
Step
3 Select [Setting] next to [HDD registration].
Setting
• <HDD registration> screen is displayed.
Step
4 Select [Setting] next to [Register internal HDD].
Setting
• <HDD registration Internal HDD> screen is
displayed.
Step
5 Check that the internal HDDs are listed on the
<HDD registration Internal HDD> screen.
• A and B represent the internal HDD numbers.
Step
6 Select whether or not to register the internal
HDDs as Main device.
Main Set
[Main]: HDD is registered as Main device.
[Not assigned]: HDD is not registered as Main
device.
• Every time you press the button, the button's function
changes between [Main] and [Not assigned].
Step
7 Select [Set] to determine your settings.
Notice
• When no HDD is registered as Main device, you
cannot use a USB memory.
Mirroring
By recording the same data on 2 HDDs that have the same
capacity, you can reduce the risk of losing recorded data in
the event of sudden crash of Main device. As the same data
are recorded on 2 HDDs, the recordable time is halved.
Notice
• Before changing the HDD operation settings (such as
turning the mirroring ON from OFF or OFF from ON
and changing the partition settings), set the pre-alarm
time of the alarm and emergency recording settings to
0 second. After setting the pre-alarm time to 0 second,
check that the PRE ALARM and ACCESS indicators
go out and then change the HDD operation settings.
Step
1 Put a checkmark in the box of [Activate the
mirroring mode].
Notice
• When you enable the mirroring function with the
recorded data stored in the HDD, the recorded data
are deleted.
• You can enable the mirroring function of this recorder
only when both of the internal HDDs A and B are set
as [Main].
• The mirroring function of this recorder can be used
with the internal HDDs only. To mirror data on external
HDDs, use a device having the mirroring function and
refer to the operation manual of the device to be used.
• In case of a failure in either HDD during mirroring, the
recorder continues recording on the normal HDD only.
When you replace the failed HDD, the data are
automatically copied to the newly mounted HDD
and they recover to the status before the failure.
(Data synchronization) When the synchronization is
interrupted by power-off, it resumes when the power is
turned back on.
• Preliminary recording is not performed while the
operation settings of normal, mirroring, or partition are
being changed.