MITSUBISHI ELECTRIC DX-TL5716U - Manual (Page 28)

24
Connecting CCTV cameras, monitors, and sensors
To OUTPUT A VIDEO or
OUTPUT A S (Y/C) connector
Connect either.
To VIDEO IN or
S(Y/C) IN connector
To VIDEO IN
connector
To OUTPUT B VIDEO
connector
To CAMERA IN
connectors
corresponding to the
camera numbers
Monitor
Sensor 1
Monitor
XGA (PC)
monitor
To XGA port
Mouse
External recording device
RS422
integral camera
Camera (up to 16 cameras)
RS232C
integral camera
RS422
integral camera
Secure the USB cord using the
supplied clamp band to prevent
disconnection. ( Page 27)
Secure the power cord using the
supplied clamp band to prevent
disconnection. ( Page 27)
For setting, see
page 111.
To ALARM IN terminals
corresponding to the
sensor numbers To GND
terminal
For setting, see
pages 57 and 58.
For setting, see page 38.
DX-ZD6UE
Up to 8 to 16 devices can be used
at the same time. (The number of
devices differs depending on the
operation manner.)
To SERIAL
BUS port
PC
For setting, see
page 114.
PC
For setting, see
pages 114 and 115.
To LAN port
<Cable termination>
Cable end connected to ALARM IN
or I/O terminal and RS485/RS422
5-7 mm strip-off
Applicable wire
0.32-0.65 mm
(AWG 28-22)
PTZ control terminals
For setting, see
page 116.
RS232C
integral camera
Power cord
Connections