Meyer Sound MM-10 - Manual (Page 44)

APPENDIX C: PHOENIX AND EN3 CABLE ASSEMBLY
44
2. If the cable has not been stripped, strip the outer shielding 1” and then strip the black, red, blue, and white wires .275”.
3. Solder the five exposed conductors to the five pins on the EN3 cord connector using the following wiring scheme.
4. Reassemble the EN3 5-pin male connector:
■ Align the coupling ring’s side notches with the cord connector’s side notches and slide the couple ring onto the cord
connector.
■ Carefully insert the end of the cable clamp housing into the cord connector until it locks into place. Snap the cable
clamps in the cable clamp housing into their compartments.
■ Slide the boot forward so it covers the cable clamp housing completely.
Pin Destinations for EN3 5-Pin Male Cable Mount Connector
1”
0.275”
Pin #5, White,
audio (+)
Pin #4, Blue,
audio (–)
Pin #2, Red,
48 V DC (+)
Pin #1, Black,
48 V DC (–)
Pin #3, Unshielded,
audio shield
Pin #5, White,
audio (+)
Pin #4, Blue,
audio (–)
REAR
FRONT
Dimple identifies Pin #1