Meyer Sound MM-10 - Manual (Page 48)

APPENDIX C: PHOENIX AND EN3 CABLE ASSEMBLY
48
2. Insert the five exposed conductors, from one end of the cable, into the five cable holes in one of the Phoenix connectors.
Use the following wiring scheme.
3. Secure the conductors by tightening the five screws in the Phoenix connector.
4. Repeat the previous steps and attach the other end of the cable to the other Phoenix connector.
5. Verify the wiring polarity is correct for both connectors.
Phoenix 5-Pin Female Cable Mount Connector
Pin #1 Black 48 V DC (–)
Pin #2 Red 48 V DC (+)
Pin #3 Shield Audio shield
Pin #4 Blue Audio (–)
Pin #5 White Audio (+)
Connector side up Side (cable attached)
Tighten screws