Meyer Sound MM-10 - Manual (Page 46)

APPENDIX C: PHOENIX AND EN3 CABLE ASSEMBLY
46
2. Insert the five exposed conductors into the five cable holes in the Phoenix connector using the following wiring scheme.
3. Secure the conductors by tightening the five screws in the Phoenix conductor.
4. Disassemble the EN3 5-pin female connector and feed one end of the cable through the boot, cable clamp housing, and
coupling ring.
5. If the EN3 end of the cable has not been stripped, strip the outer shielding 1” and then strip the black, red, blue, and
white wires .275”.
Phoenix 5-Pin Female Cable Mount Connector
Disassembled EN3 5-Pin Female Cable Mount Connector
Pin #1 Black 48 V DC (–)
Pin #2 Red 48 V DC (+)
Pin #3 Unshielded Audio shield
Pin #4 Blue Audio (–)
Pin #5 White Audio (+)
Connector side up Side (cable attached)
Tighten screws
Cable clamp
housing
Boot Coupling ring
Cord connector