Meyer Sound MM-10 - Manual (Page 45)

MM-10 OPERATING INSTRUCTIONS
45
5. Repeat the previous steps to attach the EN3 5-pin female connector to the other end of the cable.
ASSEMBLING EN3-TO-PHOENIX LOUDSPEAKER CABLES
When connecting MM-10XP loudspeakers equipped with EN3 connectors to the MPS-488HPp power supply, you need an
EN3 5-pin female to Phoenix 5-pin female cable. The following procedure documents how to assemble this cable. If you are
starting with an EN3-to-pigtail cable (included with the MM-10XP), you can skip steps 4–7 in this procedure.
To assemble an EN3-to-Phoenix cable:
1. If cable has not been stripped, strip the outer shielding 1” and then strip the black, red, blue, and white wires .275”.
Pin Destinations for EN3 5-Pin Female Cable Mount Connector
Assembled EN3-to-Phoenix Cable
Pin #5, White,
audio (+)
Pin #4, Blue,
audio (–)
Pin #2, Red,
48 V DC (+)
Pin #1, Black,
48 V DC (–)
Pin #3, Unshielded,
audio shield
Pin #5, White,
audio (+)
Pin #4, Blue,
audio (–)
REAR
FRONT
Dimple identifies Pin #1
1”
0.275”