Motorola Netopia 3342N - Manual (Page 229)

229
You can include one or more of the following arguments with the download command. If you omit argu-
ments, the console prompts you for this information.
• The server_address argument identifies the IP address of the TFTP ser ver from which you want to
copy the Motorola Netopia® Gateway configuration file.
• The filename argument identifies the path and name of the configuration file on the TFTP ser ver.
• If you include the optional confirm keyword, the download begins as soon as all information is entered.
You can also download an SSL cer tificate file from a trusted Cer tification Authority (CA), on platforms that
suppor t SSL, as follows:
download [-cert] [ server_address ] [ filename ] [confirm]
install [ server_address ] [ filename ] [confirm]
(Not suppor ted on model 3342/3352)
Downloads a new version of the Motorola Netopia® Gateway operating software from a TFTP (Trivial File
Transfer Protocol) ser ver, validates the software image, and programs the image into the Motorola Neto-
pia® Gateway memor y. After you install new operating software, you must restar t the Motorola Netopia®
Gateway.
The server_address argument identifies the IP address of the TFTP ser ver on which your Motorola Neto-
pia® Gateway operating software is stored. The filename argument identifies the path and name of the
operating software file on the TFTP ser ver.
If you include the optional keyword confirm, you will not be prompted to confirm whether or not you want
to per form the operation.
license [key]
This command installs a software upgrade key. An upgrade key is a purchased item, based on the serial
number of the gateway.
log message_string
Adds the message in the message_string argument to the Motorola Netopia® Gateway diagnostic log.
loglevel [ level ]
Displays or modifies the types of log messages you want the Motorola Netopia® Gateway to record. If you
enter the
loglevel command without the optional level argument, the command line inter face dis-
plays the current log level setting.
You can enter the loglevel command with the level argument to specify the types of diagnostic mes-
sages you want to record. All messages with a level number equal to or greater than the level you specify
are recorded. For example, if you specify loglevel 3, the diagnostic log will retain high-level informational
messages (level 3), warnings (level 4), and failure messages (level 5).
Use the following values for the level argument: