Motorola Netopia 3342N - Manual (Page 293)

293
set security state-insp xposed-addr exposed-address# " n "
Allows you to add an entr y to the specified list, or, if the list does not exist, creates the list for the stateful
inspection feature.
xposed-addr settings only apply if NAT is off.
Example:
set security state-insp xposed-addr exposed-address# (?): 32
32 has been added to the xposed-addr list.
Sets the exposed list address number.
set security state-insp xposed-addr
exposed-address# "
n " start-ip ip_address
Sets the exposed list range star ting IP address, in dotted quad format.
set security state-insp xposed-addr
exposed-address# "
n " end-ip ip_address
Sets the exposed list range ending IP address, in dotted quad format.
32 exposed addresses can be created. The range for exposed address numbers are from 1 through 32.
set security state-insp xposed-addr
exposed-address# "
n " protocol [ tcp | udp | both | any ]
Sets the protocol for the stateful inspection feature for the exposed address list. Accepted values for proto-
col are tcp, udp, both, or any.
If protocol is not any, you can set por t ranges:
set security state-insp xposed-addr
exposed-address# "
n " start-port [ 1 - 65535 ]
set security state-insp xposed-addr
exposed-address# "
n " end-port [ 1 - 65535 ]