Motorola Netopia 3342N - Manual (Page 169)

169
Filtering example #2
Suppose a filter is configured to block all incoming IP packets with the source IP address of 200.233.14.0,
regardless of the type of connection or its destination. The filter would look like this:
This filter blocks any packets coming from a remote network with the IP network address 200.233.14.0.
The 0 at the end of the address signifies any host on the class C IP network 200.233.14.0. If, for example,
the filter is applied to a packet with the source IP address 200.233.14.5, it will block it.
In this case, the mask, must be set to 255.255.255.0. This way, all packets with a source address of
200.233.14.x will be matched correctly, no matter what the final address byte is.
☛
Note:
The protocol attribute for this filter is Any by default. This tells the filter to ignore the IP protocol
or type of IP packet.
Design guidelines
Careful thought must go into designing a new filter set. You should consider the following guidelines:
• Be sure the filter set’s overall purpose is clear from the beginning. A vague purpose can lead to a faulty
set, and that can actually make your network less secure.
• Be sure each individual filter’s purpose is clear.
• Determine how filter priority will affect the set’s actions. Test the set (on paper) by determining how the
filters would respond to a number of different hypothetical packets.
• Consider the combined effect of the filters. If ever y filter in a set fails to match on a par ticular packet,
the packet is:
• For warded if all the filters are configured to discard (not for ward)
• Discarded if all the filters are configured to for ward
• Discarded if the set contains a combination of for ward and discard filters