Minicom Advanced Systems 3000 - Manual (Page 18)

DS VISION 3000
17
SYSTEM TUNING
Receiver
DCL side 1
Receiver
DCL side 2
Video
Speakers /
Audio
Serial port /
device
VIDEO 1
1 2
TUNING VIDEO 2 AUDIO
SERIAL 1 5VDC SYSTEM OUT SERIAL 2 SYSTEM IN
Video
Speakers /
Audio
Serial port /
device
System In
CATx cable from
Transmitter/Broadcaster or
Line Splitter/L or Receiver
DCL unit
System Out
CATx cable to Line Splitter/L
or Receiver* unit
* Receivers refers to any of the following:
Receivers
Receivers L
Receivers DCL
Screen 1 Screen 2
Figure 22 Receiver DCL connections
Connecting CATx cables
The connections are illustrated in Figure 21 and Figure 22 above.
Connecting the Broadcaster/Transmitter
Connect CATx cables to the System ports of the Broadcaster/Transmitter and the
System In ports of Receivers/L/DCL or Line Splitters/L.
Connecting/cascading a Line Splitter/L
Connect CATx cables to the System Out ports of the Line Splitter/L and the System
In ports of Receivers/L/DCL or further Line Splitters/L.
Cascading a Receiver DCL
Connect a CATx cable to the System Out port of the Receiver DCL and the System
In port of a Receiver/L/DCL or Line Splitter/L.
Connecting to the power supply
Connect the Transmitter/Broadcaster and all Receiver and Line Splitter units to the
power supply using the AC/DC adapters provided. If using third party power
adapters, ensure correct polarity (Center negative) and voltage – see the Tech
specs.
Once the system is connected the DS Vision system broadcasts to all remote
monitors/speakers. Note! You can use the Service Utility provided to broadcast
content to specific monitors or groups of monitors, see DS Vision system
management on page 19 below.