Minicom Advanced Systems 3000 - Manual (Page 40)

DS VISION 3000
39
Display Data Channel (DDC) hotkey
Display Data Channel (DDC) is a VESA standard for exchanging information
between a monitor and a video adapter.
Update the DDC during the initial installation of the system, this will enable
emulation of the selected monitor DDC information to the computer when it boots
the next time.
To update the DDC:
1. Select a Receiver and press Get DDC to read the DDC from the monitor attached
to it and save it to file.
2. Select the Transmitter/Broadcaster and press Set DDC to read from the saved file
and upload it to the Transmitter/Broadcaster.
Get stored DDC button – Get the DDC stored in the Transmitter/Broadcaster flash
memory and save it as a file on the computer’s hard disk. Note: This is the DDC
data that will be read by the player connected to the Transmitter/Broadcaster.
Service
To restore factory defaults, select the desired device and press Restore to factory
settings. Note! All configuration and tuning adjustments will be lost.
Broadcaster’s Local Serial port
This is for serial control of the local monitor. By default serial control is disabled.
Enable – Press Enable to connect the system serial data to the local monitor-
downstream only.
Bi directional – Once serial control is enabled you can press Bi directional to
enable a serial bi-directional connection with the local monitor – like any remote
monitor in the system.