Minicom Advanced Systems 3000 - Manual (Page 26)

DS VISION 3000
25
Figure 29 Manually displayed topology
3. To define the units connected to the ports, click the checkbox of a port or a
number of ports that have the same device connected.
4. Click . A drop-down menu appears.
5. Select the device type. Note! When the device is a Line Splitter, repeat the
process of defining the connected devices for each port of the Line Splitter.
Naming a port
To give a port an identifying name:
1. Check the port number (ensure that no other ports are checked). In the manual
section, Set device name: appears.
2. Type a new name for the port - You can give ports identical names. This name
appears immediately on the left.
Saving a topology
To save a topology choose File/Save or Save as. Save the topology.
To restore the topology choose File/Restore. Find the saved topology and click
Open. The stored topology appears. Note! The most recent saved topologies appear
in the File menu.
Saving a Group
You can save a Group to include particular ports. Once defined, you can send
instructions to the defined Group without needing to choose the individual ports.
To save a Group: