Matsushita CF-30 - Manual (Page 33)

9-11
9.2. Reassembly Instructions
9.2.1. Attention when CF-30 series is repaired
• Please execute writing BIOS ID when you exchange the Main Board.
• Parts (Sheet and rubber) etc. related various the Conductive Cloth and Heat Spreader cannot be recycled. Use new parts.
9.2.2. Setting the Antenna PCB L and R
1. Set the Antenna PCB L and R using the 2 Screws. <N2>
2. Fix the W-LAN ANT Cover L and R using the 4 Screws.
<N2>
Screws <N2>: DRHM5054XA
Q Arranging the Antenna L and R Cables
<N2>
<N2>
<N2>
<N2>
LCD Rear Cabinet Ass’y
Antenna PCB R
Antenna PCB L
W-LAN ANT Cover R
W-LAN ANT Cover L
<N2>
<N2>
Safety Working
Safety Working
X
X
X
X
Attach the Cable Tape
X
X
X
X Attach the Cable Tape
Attach the Rear
Screw Sheet
Safety Working
Attach the Cable Tape
Tighten of Screw Tighten of Screw
Match to the corner.
Coming off the tape is allowed.
Insert the Cable between the pins.
Insert the Cable between the pins.
Match it to the protrusion side and
attach it between the bosses.
Attach it fitting to the corner.
Match to the corner.
Put it along the inside of boss on X part.
Cable color : black
Cable color : grey
Fit only this part to the groove.
Match it to the concave side and
attach it between the bosses.
Place the Antenna Sub Place the Antenna Main