Matsushita CF-30 - Manual (Page 53)

9-31
Q Preparation oh HDD ASSY
0 1
0 1
Attach the HDD Tape S
HDD is set
Attach the HDD Tape L
7 1
10 1
20 1
* Notes:
1. Apply the load when attaching the parts. 20N to 30N (2 to 3Kgf)/cm2
Fit to the corner.
Turn it to the board side (back side).
1 1
Important Parts
for Safety
Safety Working
Attach the Fuse Sheet
Back Side
0 2
Attach the Heater Fixed Tape
16 2
Insert the HDD FPC Ass’y
Connect the Connector
Heater is set
HDD FPC Ass’y
Valley Fold Mountain Fold
1. Do not gouge when inserting and removing the socket.
2. Do not drop HDD or add any impacts on it.
3. Insert CN into the end firmly.
4. Apply the load when attaching the parts. 20N to 30N (2 to 3Kgf)/cm2
Check the part number.
Heater
Do not fold because the thermal
fuse exists in this part.
Lead Wire
HDD
Fuse
Do not bend the bending
part of Heater
Turn the surplus into the back.
Attach it pushing the shaded
part not to push the fuse.