Matsushita CF-30 - Manual (Page 42)

9-20
Q Assembly of LAN, Modem and MDC
Q Assembly of Main PCB
Safety Working
MDC
5 1
15 1
Tighten of
Screw
Tighten of
Screw
Tighten of
Screw
Tighten of
Screw
LAN Cable
is installed.
Modem Cable
is installed.
Modem LAN Case
is installed.
Cable Coil
Attach the DMD Cable Sheet
Order of fixing
Screw Screw
* Notes:
1. Apply the load when attaching the parts. 20N to 30N (2 to 3Kgf)/cm2
Pass the Cable to the back
from the hole of the A side.
(Remove 2 places)
Match to the edge of the Connector. 1
Process the cable and cover
with MDM Cable Sheet
Separate from the coil.
Attach space
Safety Working
Safety Working
Attach the PET Sheet
0 1
0 1
1 2
Cable SATA Signal Insertion
Sheet wrap
Safety Working
* Notes:
1. Apply the load when attaching the parts. 20N to 30N (2 to 3Kgf)/cm2
Insert the connector wrapped with the
sheet into the connector on the board.
Bend the cable avoiding the connector.
Connect the LAN cable.
Put the cable in a U-shape into the intermediate
chassis aperture next to the Connector.
Insert the FFC of the card
connector into the connector
on the main board.
Insert the FFC of the card connector into
the connector on the main board.
Do not insert the connector incompletely.
(Note: Insert diagonally.)