InFocus 560 - Manual (Page 25)

LitePro 560/570 User’s Guide 17
Using the LitePro
This section describes how to use and make adjustments to the
LitePro 560/570. It also provides a reference to the remote control
buttons and the menu commands.
Basic Image Adjustment
• If the image is not completely displayed, adjust the height of the
LitePro (page 18) or use the arrow buttons to center the image
(page 21).
• If the image is out of focus, rotate the lens to focus it (page 18).
• If the image still looks bad after you have adjusted the focus,
adjust the signal synchronization (page 27) and/or the tracking
(page 33).
• If the colors do not look right, adjust the brightness (page 26),
then adjust the sync again (page 27).
Turning the LitePro Off
It is very important to allow the projector to cool down before turning
it completely off. Turning the projector off is a two-step process:
1. Press the standby button on the remote.
• The bulb turns off, but the fans remain on to cool the LCD.
2. After a few minutes, when the projector has cooled, press the “ Ο
”
side of the power switch to turn the projector completely off.
Using the Remote Control
Point the remote control at the projection screen or at the front of the
LitePro. The range for optimum operation of the remote control is a
total of about 25 feet. If you point the remote at the projection screen,
the distance to the screen and back to the LitePro should be less than
or equal to 25 feet.
USING.FRA Page 17 Tuesday, January 28, 1997 9:55 AM