InFocus 560 - Manual (Page 27)

Using the LitePro
LitePro 560/570 User’s Guide 19
Switching to the Spare Lamp
The LitePro was shipped with two projection lamps. To avoid
breaking during shipping, they are not installed at the factory. You
must install them before you can use the LitePro. Refer to the “Read
Me First” document that was shipped with your LitePro for
instructions. “Replacing the Projection Lamps” on page 40 also
describes this procedure.
When both lamps are installed in the LitePro, only one is used at a
time. The other is available as a spare for when the active lamp fails.
The average lamp life is about 50 hours.
To switch to the spare lamp:
• Gently slide the lamp changer knob to the other side of the
projector as shown here.
When switching lamps, be careful not to touch the
exhaust grill on the door. This area is very hot when
the projector is operating.
Figure 13. Switching to the Spare Lamp
USING.FRA Page 19 Tuesday, January 28, 1997 9:55 AM