Intermec 6620 - Manual (Page 71)

SECTION 3 6620 Recovery Procedures
6620 Hand-Held Computer Technical Reference 3-9
Recovering from Parallel CD-ROM
L oad “Recovery Windows,” then eject and reinsert the 6620
Recovery CD-ROM. If the CD-ROM fails to AutoPlay, do
the following to manually start the recovery procedures:
a. Use “Windows Explorer” to find the CD.
b. Click the right mouse button on the CD and click
the AutoPlay button. The “Recovery/Re-Image
Utility” window appears (page 3-6).
1. Select Image the Main Data Partition, then click
the Continue button to continue.
2. Click the OK button on the “Recovery Utility” warn-
ing, if it is displayed (page 3-7), to continue. Use the
applicable Browse buttons to ensure the correct CD-
ROM drive (Source volume) is selected, and the Des-
tination volume is the drive assigned to the “Main
Data” partition via the “Image the Main Load” page
(page 3-8).
3. Click the Image Main Load button to continue. The
drive will be formatted and loaded with a “Full Load”
of Windows 95.
4. When done, click the Finish button to exit the “Recov-
ery Utility” window, then exit Windows. The “Main
Data” partition restores the 6620 Computer to normal.
After entering your name (and optionally, your company
name), and accepting the license agreement, Windows
prompts you for your Certificate of Authenticity from Micro-
soft as it starts. This is necessary to continue the recovery.