Intermec 6620 - Manual (Page 82)

SECTION 3 6620 Recovery Procedures
3-20 6620 Hand-Held Computer Technical Reference
Image-to-Image Copying
This process is for those who installed the application on a
“Master 6620” unit and wish to duplicate this master image
on one or more hand-held computers.
This process assumes that you have a 6620 Desktop Dock, a
network hub, and two network cables to network either a
desktop PC (containing a full 6620 image) or another 6620
(in another single dock) to be cloned directly. Also, either a
floppy drive or access to a free PC Card slot is required.
Restoring Operation of the Source
6620 Computer (MASTER)
1. Shut down Windows and the 6620 Computer.
2. Boot the system with the Peer Networking disk.
3. Press “3” to restore normal operation, then press [En-
ter]. Once the configuration is complete, you will be
prompted to eject the floppy disk.
4. Eject the floppy disk, then press any key to boot the
system into Windows.
If the network recovery PC card is used, shut down the sys-
tem and reboot without the PC Card.
Configuring a Source 6620
Computer (MASTER)
Do these steps on the source 6620 Computer. This comput-
er is considered the “master”:
1. Prepare the Main Data Partition exactly as you want
it set up.
2. Boot the system with the special Peer Networking dis-
kette or PC Card created using the Toolkit CD-ROM.