Icom IC-V85-T - Manual (Page 18)

5
2
PANEL DESCRIPTION
D Keypad
[FUNC]
Access to secondary function.
[CALL]
Selects the call channel. (p. 26)
[MR]
➥ Selects a memory mode. (p. 26)
➥ After pushing
[FUNC] , enter into memory pro-
gramming/editing mode. (pgs. 27–29)
➥ After pushing [FUNC] , programs/transfers
VFO/memory or call channel contents into
memory channel/VFO when pushed and held
for 1 sec. (pgs. 27–29)
[CLR]
Selects VFO mode, aborts direct frequency input,
or cancels scanning, etc. (pgs. 17, 35)
[1• TONE ]
➥ Input digit “1” during frequency input, memory
channel selection, etc. (pgs. 17, 26)
➥ After pushing
[FUNC] , selects the subaudible
tone function. (pgs. 22, 39)
[2• P . BEEP ]
➥ Input digit “2” during frequency input, memory
channel selection, etc. (pgs. 17, 26)
➥ After pushing [FUNC] , turns the pocket beep
function ON and OFF. (p. 41)
[3• T . SCAN ]
➥ Input digit “3” during frequency input, memory
channel selection, etc. (pgs. 17, 26)
➥ After pushing [FUNC] , starts tone scanning.
(pgs. 24, 42)
[4• DUP ]
➥ Input digit “4” during frequency input, memory
channel selection, etc. (pgs. 17, 26)
➥ After pushing [FUNC] , selects duplex function
(–duplex, +duplex, simplex). (p. 22)
[5•
SCAN
]
➥ Input digit “5” during frequency input, memory
channel selection, etc. (pgs. 17, 26)
➥ After pushing [FUNC] , starts scanning. (p. 35)
5
SCAN
4
DUP
3
T.SCAN
2
P.BEEP
1
TONE
D
CLR
C
MR
B
CALL
A
FUNC
A
1
4
7
FUNC
TONE
DUP
PRIO
B
2
5
8
CALL
P.BEEP
SCAN
SET
C
3
6
9
SKIP
T.SCAN
MR
H/M/L
D
0
CLR
BANK
OPT
ENT