Troubleshooting – Icom IC-V85-T User Manual

Page 75

Advertising
background image

62

15

TROUBLESHOOTING

1

2

3

4

5

6

7

8

9

10

11

12

13

14

15

16

17

18

19

PROBLEM

No power comes ON.

No sound comes from the
speaker.

Transmitting is impossible.

No contact possible with
another station.

Frequency can not be set.

Program scan function
can not start.

Memory scan function can
not start.

The displayed frequency is
erroneous.

Can not charge the battery
with BC-167A/D.

If your transceiver seems to be malfunctioning, please check the following points before sending it to a service center.

POSSIBLE CAUSE

• The batteries are exhausted.
• The battery polarity is reversed.
• Battery’s temperature protection circuit is ac-

tivate.

• Volume level is too low.
• Different tone is selected with tone/DTCS

squelch.

• The batteries are exhausted.

• Different tone is selected with tone/DTCS

squelch.

• The key lock function is activated.

• Memory mode or call channel is selected.

• Memory mode or call channel is selected.
• Same frequencies are programmed both “

✱A”

and “

✱b” of scan edge memory channel.

• VFO mode or call channel is selected.
• The programmed memory channel is only

one.

• The CPU malfunctioned.
• External factors caused a fault.

• Turn the transceiver’s power ON.

SOLUTION

• Replace the batteries or charge the battery pack.
• Check the battery polarity.
• Cool down the BP-227.

• Rotate

[VOL]

to suitable level.

• Check the tone using tone/DTCS scan.

• Replace the batteries or charge the battery pack.

• Check the tone/DTCS using tone scan.

• Push

[FUNC]

then push and hold

[

]

(

ENT

)

for 1 sec. to cancel the function.

• Push

[CLR]

to set VFO mode.

• Push

[CLR]

to set VFO mode.

• Programming different frequencies in “

✱A” and

✱b” respectively.

• Push

[MR]

to set memory mode.

• Program more than 2 memory channels.

• Reset the transceiver.
• Remove and re-attach the battery pack or battery

case.

• Turn the transceiver’s power OFF, then connect

the BC-167A/D to charge.

REF.

pgs. 9, 13–15
p. 10

p. 19
p. 42

pgs. 9, 13–15

p. 42

p. 20

p. 17

p. 17
p. 27

p. 26
p. 27

p. 61
p. 9

pgs. 13 ,17

Advertising
This manual is related to the following products: