Skip channels, Scan resume condition – Icom IC-V85-T User Manual
Page 50
37
8
SCAN OPERATION
■
Skip channels
In order to speed up the scan rate, you can select memory
channels you don’t wish to scan as skip channels.
q Push
[MR]
to select memory mode, if necessary.
• “X” appears.
w Select a memory channel to set as a skip channel.
e Push
[FUNC]
and
[
SKIP
]
(6) to toggle the skip setting ON
and OFF.
• “SKIP” appears when the channel is set as a skip channel.
■
Scan resume condition
When a signal is received during scanning, the scan resume
condition determines what action the transceiver takes. The
transceiver has 2 scan resume conditions available as
illustrated below. Use
SET MODE
to select the one which best
suits your needs.
q Push
[FUNC]
, then push
[
SET
]
(8) to enter
SET MODE
.
w Push
[
Y
Y
]
or
[
Z
Z
]
several times until “SCP” or “SCt” ap-
pears.
e Rotate
[VOL]
to select the desired scan resume condition.
• Pause scan:
When receiving a signal, scan pauses
on the signal until it disappears. Re-
sumes 2 sec. after the signal disap-
pears.
• Timer scan:
When receiving a signal, scan pauses
on the signal for 5 sec., 10 sec. or 15
sec., then resumes.
r Push
[
✱
ENT
]
(or
[CLR]
) to set and
exit
SET MODE
.
Timer scan
Pause scan
USING
SET MODE
Push
SKIP
FUNC
A
6
“SKIP” appears