Icom IC-V85-T - Manual (Page 43)

30
6
MEMORY/CALL OPERATION
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
■
Memory bank selection
The IC-V85 has a total of 10 banks (A to J). Each memory
channel, 0 to 99, may be assigned to one of the banks for
easy memory management.
q Push [MR] to select memory mode.
w Push [FUNC] and [ BANK ] (#) to
enter memory bank selection.
• Bank indicator blinks.
e Rotate [VOL] to select the de-
sired bank, A to J.
• Banks that have no programmed
contents are skipped.
r Push [ ✱
ENT ] (or [CLR] ) to select
the bank.
• Indicator stops blinking.
t Push [ Y Y ] or [ Z Z ] to select the channel in the bank.
• No channel numbers are displayed for memory bank operation.
y To return to regular memory condition, push [FUNC] and
[ BANK ] (#) to enter memory bank mode, then push [ ✱
ENT ]
(or [CLR] ).
■
Memory bank setting
q Push [MR] to select memory mode, then select the desired
memory channel via [ Y Y ] or [ Z Z ] .
w Push [FUNC] and [
SET
] (8) to
enter
SET MODE
.
e Push [ Y Y ] or [ Z Z ] several times
until “bAk” appears.
r Rotate [VOL] to select the de-
sired bank.
t Push [
✱
ENT ] (or [CLR] ) to assign the channel to the bank
and return to regular memory condition.
y Repeat steps q to t to assign another memory channel
to the same or another bank.
NOTE: Display type setting (pgs. 20, 53) in INITIAL SET
MODE must be selected “FR,” otherwise the memory bank
operation cannot be performed.
DUP SCAN
PRIO SET H/M/L
OPT SKIP
BANK TONE T.SCAN P.BEEP
A B D C
CALL
ENT
MR CLR FUNC
PWR
9 8 7
4
1 2 3
5 6 0
[VOL]
A
FUNC
8
SET
ENT
Push MR
C
DUP SCAN
PRIO SET H/M/L
OPT SKIP
BANK TONE T.SCAN P.BEEP
A B D C
CALL
ENT
MR CLR FUNC
PWR
9 8 7
4
1 2 3
5 6 0
[VOL]
A
FUNC
BANK
ENT
Push MR
C