Turn on the monitor, Turn on the computer – InFocus 760 User Manual

Page 21

Advertising
background image

Connecting the LitePro 760

12

LitePro 760 User’s Guide

Connecting a Macintosh

Follow this procedure if your computer is a Mac II or any Mac with a
separate monitor.

1. Locate your monitor cable; it connects the monitor to the com-

puter. Unplug it from the computer. Remember where you
unplugged the cable from the computer, you will plug the
LitePro cable into this same connector in the next step.

2. Attach one of the Mac adapters to the “Computer” end of the

LitePro cable. Plug the adapter (with the cable attached) into the
monitor connector on the computer.

• If your monitor is 13 inches or smaller, set the switch on the

adapter to “LoRes”. If the monitor is larger than 13 inches, set
the switch to “HiRes”. If your computer does not have a
monitor, set the switch to “NoMon”.

3. Attach the other Mac adapter to the “Monitor” end of the LitePro

cable. Plug the adapter (with the cable attached) into the com-
puter’s monitor cable.

4. Tighten the thumb screws on all the connectors to ensure proper

grounding.

5. Turn on the monitor.

6. Turn on the LitePro 760 by pressing the “1” side of the power

switch. (Refer to “Powering Up the LitePro” on page 15.)

7. Turn on the computer.

Osprey.bk Page 12 Monday, December 11, 2000 1:38 PM

Advertising