InFocus 760 - Manual (Page 6)

LitePro 760 User’s Guide i
Safety Summary
Please read these instructions before using your LitePro projector.
Failure to comply with these instructions could result in fire, electrical
shock, personal injury or equipment damage.
These graphics are used throughout this manual to draw your atten-
tion to important information about the LitePro:
Information that may be unusual or unexpected.
Information that helps you avoid damage to your
equipment.
Information that helps you avoid personal injury.
These graphics are used on the LitePro:
Attention - Refer to the User’s Guide for important safety
information.
Fuse - Refer to “Replacing the Fuse” on page 31 of this
User’s Guide for important safety information.
Hot Surface - Do not touch until the LitePro has cooled.
Power Source
Use only a three-wire grounding type power source. The power
source should not exceed 250 volts rms between the supply
conductors or between either conductor and the ground.
Power Cord
Use only the power cord that was shipped with the LitePro. Although
other power cords might be similar in appearance, they have not
been safety-tested with the LitePro. Never use a power cord if it has
become damaged or frayed. Contact your In Focus dealer or call In
Focus if you need to replace your LitePro power cord.
!
Osprey.bk Page i Monday, December 11, 2000 1:38 PM