InFocus 760 - Manual (Page 24)

Connecting the LitePro 760
LitePro 760 User’s Guide 15
Powering Up the LitePro
Turn on the projector by pressing the “|” side of the power switch on
the side of the projector.
• After about 5 seconds, the projector test pattern appears. (If it
does not, refer to “Troubleshooting” on page 35. If you are using
an IBM-compatible laptop computer, refer to the Appendix for
monitor re-activation commands.)
• If the image is not projected directly on the screen, adjust the
height of the elevator. Refer to “Adjusting the Height” on page 18
for instructions.
• You may also need to focus the projector. Turn the focus ring on
the projector’s lens until the focus is satisfactory. Refer to
“Focusing the Image” on page 17 for more information.
With some computers, the order in which you power up
the equipment is very important. We recommend that you
always turn on the computer LAST. Turn on all other
pieces of equipment (including the computer’s monitor)
before you turn on the computer.
Turning the LitePro Off
It is very important to allow the projector to cool down before turning
it completely off. Turning the projector off is a two-step process:
1. Press the standby button on the remote.
• The bulb turns off, but the fans remain on to cool the LCD.
2. After a few minutes, when the projector has cooled, press the “O”
side of the power switch to turn the projector completely off.
Osprey.bk Page 15 Monday, December 11, 2000 1:38 PM