InFocus 760 - Manual (Page 47)

Troubleshooting
38 LitePro 760 User’s Guide
Problem: Image and menus are reversed left to right
• Rear projection mode is probably set. To switch back to forward
projection:
1. Press the menu button on the remote to display the menu.
2. Select “Rear Projection”. Press the up or down button to
switch back to forward projection.
3. Press menu again to remove the menu.
Problem: LitePro displays vertical lines, “bleeding” or spots
• Adjust the contrast. Refer to “contrast” on page 20 for more
information.
• The projection lens may need cleaning.
Problem: Image is “noisy” or streaked
• Adjust the contrast. Refer to “contrast” on page 20 and page 23
for more information.
• Adjust the Sync. Refer to “sync” on page 20 for more information.
Problem: Projected colors don’t match the monitor’s colors
• Adjust the brightness and/or contrast. Remember that, just as
there are differences in the displays of different monitors, there
are often differences between the computer image and the
projected image. Refer to “contrast” and “brightness” on page 20
and for more information.
Problem: “EEPROM Failed” displays on the menu
• One of the integrated circuits inside the LitePro has failed. The
only functionality that is lost is that the LitePro will reset the
menu functions to their factory defaults when you turn it off. Call
In Focus Technical Support; refer to “If You Need Assistance” on
page 3.
Problem: Remote not operating correctly
• You may need to replace the batteries in the remote. Refer to
“Replacing Batteries in the Remote Control” on page 30 for
instructions.
Osprey.bk Page 38 Monday, December 11, 2000 1:38 PM