Replacing the projection lamps, Follow these steps to replace the lamps, Disconnect the power cord from the litepro – InFocus 760 User Manual
Page 37: Hold the lamp door open with one hand
Maintenance
28
LitePro 760 User’s Guide
Replacing the Projection Lamps
When a lamp fails, be sure to replace it with another EVD bulb (36
volt, 400 watt) from General Electric or OSRAM. These bulbs provide
the best performance and longest bulb life.
You can order replacement lamps from In Focus. Refer to
“Accessories” on page 43 for information.
Follow these steps to replace the lamps.
1. Press the “0” side of the LitePro’s power switch. Then, allow the
LitePro to cool thoroughly (at least 20 minutes).
Allow the LitePro to cool for at least 20 minutes before
you attempt to open the lamp door! The inside of the
LitePro lamp housing can become very hot. Use extreme
care.
2. While you’re waiting for the LitePro to cool, find a clean soft
cloth that you can use to hold the bulbs. You can also use the plas-
tic bag that came with the lamp. Holding a bulb with your bare
fingers can damage the bulb and shorten its life.
3. Disconnect the power cord from the LitePro.
4. Open the lamp door. To do this, push in on the two buttons as
shown below, then lift the door up.
5. Hold the lamp door open with one hand.
Osprey.bk Page 28 Monday, December 11, 2000 1:38 PM