ITT SMART SWITCH 801P5 - Manual (Page 18)

Page 14 Installation and Operation Manual
NOTE
DISPLAYING SET POINTS.
Programmed set points can be viewed on the front panel display
by pressing the corresponding [S1] or [S2] key. To view the
increasing value for Switch 1, press [S1 INCR]. To view the
decreasing value for Switch 2, press [S2 DECR].
Figure 7 Press the Incr / Decr Buttons
to Display Set Points for S1 / S2
After 5 seconds of keypad inactivity, the display automatically
changes back to the system pressure display. While viewing set
points, the output functions remain active.