Command summary, Cms-6r4 series - user’s guide – I-Tech Company CMS 6R4 Series User Manual
Page 100
10-2
CMS-6R4 Series - User’s Guide
10.2. Command Summary
Function
Command Syntax
Command Availability
Supervisor Non-Super.
Initiate Boot Cycle
/BOOT[,Y] <n> [Enter]
/BO[,Y] <n> [Enter]
X
X
Connect
/C <n> [n] [Enter]
X
X
Copy RS232 Port Parameters
/CP <n> [Enter]
X
Third Party Disconnect
/D[,Y] <n> [n] [Enter]
/D[,Y] * [Enter]
X
Set Plugs to Default State
/DPL[,Y] [Enter]
X
Erase Buffer
/E[,Y] <n> [n] [Enter]
/E[,Y] * [Enter]
X
Set System Parameters
/F [Enter]
X
Set to Factory Defaults
/FD[,Y] [Enter]
X
Help Menu
/H [Enter]
X
X
Reset Network Interface
/I [Enter]
X
Display Site ID
/J [Enter]
X
X
Set Network Port Parameters
/N [Enter]
X
Turn Off Plug
n
/OFF[,Y] <n> [Enter]
/OF[,Y] <n> [Enter]
X
X
Turn On Plug
n
/ON[,Y] <n> [Enter]
X
X
Set RS232 Port Parameters
/P <n> [Enter]
X
Set Plug Parameters
/PL <n> [Enter]
X
Display Main Status Screen
/S [Enter]
X
X
Display Port Diagnostics
/SD [Enter]
X
X
Display Network Status
/SN [Enter]
X
Telnet Connection Out
/TELNET <ip>[port][raw] [Enter]
X
Send Parameters to a File
/U [Enter]
X
X
Upgrade Firmware
/UF [Enter]
X
Unlock Invalid Access Lockout
/UL [Enter]
X
View Password Directory
/V [Enter]
X
Display Port Parameters (Who)
/W [n] [Enter]
X
X
Exit Command Mode
/X[,Y] [Enter]
X
X
Resident Disconnect
^X
X
X
The "
,Y" argument can be included to suppress the command confirmation prompt.
Command only applies to the ports and plugs that are allowed by the password/account.
Non-Supervisors are not allowed to create third party connections, or connect to ports that are
not allowed by their password/account.
Third Party Disconnect: Disconnects two or more nonresident ports. Must be issued from a
third port with Supervisor command capability.
The Non-Supervisor Mode Help Menu will not include commands that are only available to
Supervisors.
Non-Supervisors can only apply this command to their resident port.
Resident Disconnect: Disconnects your resident port from another port. The disconnect
sequence can be redefined via the Port Configuration Menus.