I-Tech Company CMS 6R4 Series - Manual (Page 92)

7-6
CMS-6R4 Series - User’s Guide
7.4.2. Port Parameters Screen - Network Port
The /W (Who) command can also be used to display configuration parameters
for the Network Port (Figure 7.5.) To display Network Port Parameters, access
the Text Interface command mode via the Network Port, using a password that
permits access to Supervisor Level commands, and then invoke the /W without
including the port number argument, as shown in the example below:
/W [Enter]
For more information on the various items displayed on the Port Parameters
Screen, please refer to the port configuration description in Section 5.5.2.
NETWORK PARAMETERS:
1. IP Address: 207.212.30.80
2. Subnet Mask: 255.255.255.0
3. Gateway Address: 207.212.30.1
4. Send MSS: 536
5. IP Security Off
TELNET PORT PARAMETERS
1. Supervisor Mode: Permit
2. Logoff Character: ^X
3. Sequence Disconnect: One Character Only
4. Inactivity Timeout: 5 Min
5. Response Type: Verbose
6. Command Echo: On
7. Accept Break: Yes
8. Discard LF: Off
9. Invalid Access Lockout: Off
CMS>
Figure 7.5: The Port Parameters Screen (Network Port Shown)