I-Tech Company CMS 6R4 Series - Manual (Page 74)

6-10
CMS-6R4 Series - User’s Guide
3. No Activity Timeout: Providing the Timeout feature is enabled at either
connected port, the No Activity Timeout can disconnect Resident Ports,
or Third Party Ports.
Note:
The No Activity Timeout also applies to Telnet "Direct
Connections" and outbound Telnet connections. For more information,
please refer to Section 6.6.
a) Serial RS232 Ports: To configure the Timeout Feature for the Serial
RS232 Ports, proceed as described in Section 5.5.3.
b) Network Port: To configure the Timeout Feature for the Network
Port, proceed as described in Section 5.5.2.
c) When the Timeout Feature is enabled, the port will automatically
disconnect if no data is received for the defined Timeout Period.
Notes:
• When two connected ports time out, both ports will exit command
mode after disconnecting.
• The Timeout value also applies to unconnected ports that are left in
Command Mode. When an unconnected port is left in Command
Mode, and no additional data activity is detected, the port will
automatically exit Command Mode when its defined timeout value
elapses.